Vaša košarica je trenutno prazna!
Prikazuje se svih 10 rezultata
-
Palmer AHMCT8
65,00 €MSRP:77,00 €AHMCT8 cable tester AHMCT 8 tests the most critical cables on the stage itself and flags up whether they are functioning or not, both visibly via LEDs and audibly via a buzzer. This makes it the perfect tool for engineers — both in the workshop and on stage.
-
-
Palmer MCT DMX
35,00 €MSRP:40,00 €3-pin / 5-pin DMX and XLR cable tester
Tests 3- and 5-pin DMX cables for continuity
Also suitable for testing 3-pin XLR microphone cables
Automatic test or manual pole selection
LED display
Including mounting brackethttps://www.youtube.com/watch?v=V_Nof4c6avY
-
Palmer MONICON
85,00 €MSRP:120,00 €MONICON – Passive Monitor Controller With Palmer Monicon, your monitor volume is always under control. The passive mini-mixer with the oversized control is inserted between the stereo output of the notebook, PC or interface and an active monitor system and thus permits convenient and precise volume control of the monitors from the workstation. The passive circuitry with only a few components has absolutely no affect on the sound. Mute and mono buttons make it possible to mute the outputs and merge the stereo output signal into a mono master signal.
https://www.youtube.com/watch?v=VUdythIEm8s
-
Palmer PAN01
75,00 €MSRP:90,00 €PAN01 Passive DI box. Jack input with paralell “THRU” output, transformer balanced XLR output. Attenuable input sensitivity, can handle both line level and speaker level signals.
-
Palmer PAN02
85,00 €MSRP:122,00 €Standard active DI box. Can be operated with 9 V batteries or 48 V phantom power. High-impedance input; higher output level than with a passive DI box. Active circuitry allows for high input impedance ( 1 meg. ohm) and higher input sensitivity (typical difference between in and out -4 dB). Maximum output impedance with phantom power operation +10 dB. Output: transformer balanced. The special “floating ground” circuitry enables ground lift even during phantom power operation. Metal case 110 x 73 x 42 mm.
https://www.youtube.com/watch?v=SDkvJrVfDyg
-
Palmer PAN04
115,00 €MSRP:150,00 €DI Box passive PAN04 consists of a housing containing the equivalent of two PAN 01s, making it a dual channel passive DI box. This „stereo” configuration makes it ideally suited for use with certain keyboards and devices which have several outputs.ive DI box. Jack input with paralell „THRU” output, transformer balanced XLR output. Attenuable input sensitivity, can handle both line level and speaker level signals
https://www.youtube.com/watch?v=vzG2H9ARmmI
-
Palmer PLI04
150,00 €MSRP:206,00 €PLI04 – Media DI Box 2-channel for PC and laptop With the new PRO MEDIA DI/ PLI04, Palmer introduces a DI-box, produced with the discerning needs of the computer-age media in mind. Using this uncomplicated method, personal computers and other consumer equipment with unbalanced outputs can be converted to balanced, in order to carry out, e.g., a presentation over a professional PA system. The PLI-04 accommodates all the common input types, TRS jacks accepting mono or stereo plugs, RCA phono sockets and a 3.5mm stereo jack input for use with the headphone output of a Laptop or similar device.
-
Palmer POCKET AMP BASS
220,00 €MSRP:275,00 €Multi-purpose bass effects pedal and preamp
Works with any bass rig, power amp, mixing desk and as headphones amp
Pad switch for use with active and passive basses
Clean, overdrive and fuzz modes
Drive and saturation controls
3-Band EQ with semi-parametric mid control
Vintage and modern cabinet simulations
Blend control for wet and dry signal mixing
3-pin XLR for balanced DI, pre or post effect switchable
Footswitch-assignable thru (tuner) output
Insert, stereo line input and ground lifthttps://www.youtube.com/watch?v=-i-E1x99Rc8
-
Palmer Pro AHMCTXL V2
100,00 €MSRP:115,00 €Pro AHMCTXL V2 – Multi-Wire Cable Tester – AHMCTXL V2 can test cables with Speakon 4-pin and 8-pin, XLR 3-pin and 5-pin, 3.5 mm and 6.35 mm TS and TRS, RCA, DIN/MIDI, USB, RJ-45 and S-Video connectors. It includes a pair of probes that enable troubleshooting cables with other types of connectors or the wiring in studios and installations.